bags|belts|filters

2-Pack of Vacuum Belt fits Hoover T-series Vacuum Cleaners that are Non-Self Propelled. This belt Replaces Hoover Part # 38528058, AH20080. When purchasing a new belt for models without brushroll On/Off Mode (meaning you cannot switch between barefloors and carpeting - without a brush shutoff), find the stretch Belts here - Hoover Part Number 38528058, AH20080.


Designed to fit the following Hoover T-Series Vacuum Cleaner Models including (but not limited to):
Windtunnel UH70120 Rewind model
UH70100
UH70105
UH70106
UH70107
UH70110
UH70115
UH70116
UH70120

Changing Your Hoover Vacuum Belt
1) Unplug the vacuum from electricity
2) With lettering on outside of belt, slide new belt over motor shaft.
3) Push other end of belt through belt guide and over metal pully, then slip around area of brushroll without bristles.
4) With belt in place, pull and side brushroll into nozzle making sure that the brushroll end caps are in the correct orientation.
5) Reposition bottom plate, aligning the three tabs along the front edge of nozzle guard with the three slots in nozzle. Rotate back into position. Slide red lower latch to lock position, and rotate red upper latch clockwise to secure bottom plate.